Inventor is a type of software where you can draw and come up with literally anything you could think of.
Step 1 was to make a 1 inch by 1 inch square in inventor and extrude it out 1 inch so you have a 1 in by 1 in by 1 in cube.
Step 2 was to make a .75 inch by .75 inch square starting in the top corner.
Step 3 was to extrude that .75 in by .75 in square in by 1 inch
Step 4 was to make a .25 in by .5 in rectangle centered at the top of the drawing.
Step 5 was to extrude that rectangle in by .25 inches.
Step 6 was to make a .5 inch by .5 inch square centered on the other part of of the drawing.
Step 7 was to extrude that square in by .25 inches
Step 8 was to draw triangles in the corners of the longer posts on the drawing
Step 9 was to extrude the triangles in by .25 inches
This is what the widget looks like finsished