3D printing assignment
My first project was the 3d printing assignment where we had to either make a headphone organizer, a phone holder, a device that holds 4 toothbrushes neatly, or an organizational device that holds 50 pennies, 40 nickels, 50 dimes, and 40 quarters. I chose to do the headphone holder.
This was my original plan where the headphone would go into the two holes, the cord would wrap around the middle part, and the lightning port would go into the rectangle. After printing it off the holes were actually too small so the headphones wouldn't fit into them. After that I went back and changed the design quite a bit so that the headphones would fit, the other design was too small so I had no room to make bigger holes so I made the entire design bigger
This was the second and final design of the project. At first it was very difficult because I had to make a lot of separate drawings for the part where the headphone actually goes in, and then I had to mirror those drawings over so that it was symmetrical. This design still works how the last one did with the headphones going into the holes and the cord wrapping around the middle part.
That's what the final product looked like with headphones in it.